Key takeaways
Three things to remember
- 01
Bone mineral density is the amount of mineral in a given area of bone, measured by a DXA scan of the hip and spine and reported as a T-score.
- 02
A T-score of -1.0 or higher is normal, -1.0 to -2.5 is low bone mass, and -2.5 or lower is osteoporosis; each standard deviation lower roughly doubles fracture risk.
- 03
Peak bone is built by about age 30, and heavy lifting, impact work, protein, calcium and enough total energy help hold it through later life.
How it works
The Mechanism
Bone is living tissue that is rebuilt all the time. Cells called osteoclasts dissolve small patches of old bone, and osteoblasts fill them back in with fresh protein scaffolding that then hardens with calcium and phosphate. One cycle at a given spot takes several months, and over roughly a decade most of the adult skeleton gets replaced. Bone mineral density reflects the balance between those two jobs: when building keeps pace with breakdown, density holds; when breakdown wins, it falls.
Most people reach peak bone mass in their late 20s to about age 30, and that peak is the bank account the rest of life draws on. Density then declines slowly in both sexes. In women it drops faster in the years around menopause, often by about 2 percent a year for several years, because estrogen normally keeps breakdown in check. Men lose bone more gradually, with testosterone and the estrogen made from it playing a similar protective role. Bone also responds to load: muscles pulling on bone and the jolt of landing are signals that tell the building cells where to add mineral, which is why heavy lifting and impact work build density and long periods of bed rest or spaceflight strip it away.
A DXA scan measures mineral per square centimeter, not true three-dimensional density, and turns the result into two numbers. The T-score compares you with a healthy young adult of the same sex, and the Z-score compares you with people your own age and sex. Each standard deviation lower on the T-score roughly doubles the risk of a fracture at that site. Density is not the whole story, though: bone quality, internal structure, falls, and age all add risk, which is why tools such as FRAX combine the hip score with other risk factors to estimate a 10 year fracture probability.
In practice
Why It Matters
Low bone density gives no warning until a bone breaks.
Bone mineral density matters because low density is silent until a bone breaks, and a hip or spine fracture in later life often means lost independence. About half of women and up to a quarter of men over 50 will break a bone due to osteoporosis, and the density you build before 30 and protect after 50 largely decides your margin. Unlike most age-related decline, bone responds to what you do: heavy resistance training, impact work, enough protein and calcium, and avoiding long stretches of low energy intake can hold or even raise it.
Common misconception
A common belief is that a normal-looking body composition DXA scan tells you your bones are fine. The whole-body bone number on a body composition scan is not used to diagnose osteoporosis; diagnosis comes from a dedicated scan of the hip and lumbar spine. A second misconception is that only people with osteoporosis-range scores break bones. Because far more people sit in the low bone mass range, most fragility fractures actually happen there, so density is best read alongside age, fall risk, and fracture history rather than as a pass or fail line.
Reference ranges
What a Healthy Range Looks Like
Normal
T-score of -1.0 or higher
Within 1 standard deviation of a healthy young adult
Low bone mass (osteopenia)
T-score between -1.0 and -2.5
Below the young adult reference; fracture risk depends on other factors too
Osteoporosis
T-score of -2.5 or lower
Diagnostic threshold at the hip or spine in postmenopausal women and men over 50
Below expected for age
Z-score of -2.0 or lower
Used for premenopausal women and men under 50 instead of the T-score
A healthy bone mineral density is a T-score of -1.0 or higher at the hip and lumbar spine, meaning your bones are within 1 standard deviation of a healthy young adult of the same sex. Scores between -1.0 and -2.5 count as low bone mass, and -2.5 or lower meets the definition of osteoporosis. For premenopausal women and men under 50, the Z-score is used instead, and a value of -2.0 or lower is flagged as below the expected range for age. These categories come from the World Health Organization and apply to dedicated hip and spine scans, not whole-body body composition scans.
What moves it
How to Improve It
Lift heavy. Do resistance training 2 to 3 times per week with loads heavy enough that about 5 reps per set is your limit, using squats, deadlifts and overhead presses that load the hips and spine; supervised trials in postmenopausal women raised spine and hip density over 8 months.
Add impact. Include 10 to 50 jumps, hops or skips on most training days, as impact signals bone building in a way that walking and cycling alone do not.
Eat enough protein. Aim for about 1.0 to 1.2 grams of protein per kilogram of body weight daily, more if you lift, since protein forms the scaffold that mineral hardens onto.
Calcium and vitamin D. Get about 1,000 mg of calcium daily, or 1,200 mg for women over 50 and men over 70, mostly from food, and keep vitamin D in the sufficient range, with 600 to 800 IU daily as the usual intake target.
Avoid low energy intake. Avoid long stretches of very low calorie intake or missed periods from heavy training, and keep alcohol to 2 drinks a day or fewer, since 3 or more daily is a recognized fracture risk factor.
Get scanned on schedule. Ask about a hip and spine DXA scan at 65 for women, earlier after menopause if you have risk factors, and around 70 for men, then repeat every 2 years or as your clinician advises.
Go deeper